PSP foam sheet extrusion production equipment group is mainly used to produce some EPS foam sheet and KT board, etc. it uses PPy as raw material. During extrusion, it injects foaming agent under high pressure, and then extrudes and foams through the action of die head, and then carries out cooling, setting, cutting, traction, winding and other work again to complete the whole process of product production. So what are the requirements for the installation of PSP foam sheet extrusion equipment?

Because the length requirement of PSP foam sheet extrusion equipment for manufacturers is very strict, the manufacturers of PSP foam sheet extrusion equipment will inform the users of the space required by the equipment before purchasing the equipment. For example, the ordinary single extrusion PSP foam sheet extruder includes a rubber extruder, a 30 meter hot air curing box and a cooling water tank. Therefore, the length of the workshop must be more than 40 meters to carry out normal production.

Before the operation of PSP foam sheet extrusion production equipment, the ground where the equipment should be located should be treated to the level, so as to avoid imbalance after the operation of the equipment. In addition to these conditions, equipment installation also needs to understand the power situation, to meet the normal operation of the equipment load transformer, in addition to these also need water, because the PSP foam sheet extrusion production equipment operation to temperature control equipment.